Versions Compared

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

 

 

 

Section
Column
width70%

By default, the

...

time-out in the PAP2T for seizing the line is set to 10 seconds. That means, when you enter the number in your (analogue) phone and dial, the PAP2T-adapter will wait another 10 seconds for additional digits. Normally this is not necessary, because most devices are using block-

...

dialling.


Question: PAP2T – How can I configure the timeout before

...

dialling?

For example:

- A user has configured a Linksys PAP2T with an analogue telephone behind it.

- The user is

...

dialling a number

- It takes 10 seconds before the user is hearing the

...

dial tone

Workaround: Use a # behind the

...

dialled number to end the

...

time-out directly.

Solution: In the WebUI of the Linksys PAP2T you can change the

...

time-out. Go to Admin-View --> Regional -->

...

Inter-digit Long Timer


User-added imageImage Modified


Change here the settings from 10 seconds to 1 second (or something in between).
User-added imageImage Modified

Analogue Gigaset DECT phones are using block-dialing, therefore you can use a timeout-setting of 1 second.

PAP2T - How to reduce long timeout before dialing

By default, the timeout in the PAP2T for seizing the line is set to 10 seconds. That means, when you enter the number in your (analogue) phone and dial, the PAP2T-adapter will wait another 10 seconds for additional digits. Normally this is not necessary, because most devices are using block-dialing.

...

For example:

- A user has configured a Linksys PAP2T with an analogue telephone behind it.

- The user is dialing a number

- It takes 10 seconds before the user is hearing the dialtone

Workaround: Use a # behind the dialed number to end the timeout directly.

...

Column
width30%