Versions Compared

Old Version 10

changes.mady.by.user Baremans, Eric

Saved on

compared with

New Version 11

changes.mady.by.user Baremans, Eric

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.
Section
Column
width70%

Introduction

Info
titleImportant

This feature is under investigation and is only allowed to be used with support from Gigaset, please contact your local Technical Sales if you would like to use this feature.

With this new feature, the N720 is connected with other platforms via IP address instead of using the SIP registration method. This feature allows:

  • Connection to Cisco platform using the Cisco Call manager
  • Providers that connect via IP address and not using SIP registration
  • SIP trunks provided by PBX systems or Internet Service Providers

After successful trial period, this feature will be official released.

N720 Software version

This feature can be used with the N720 Release 89 and higher.

 

Expand
titleN720 Configuration

N720 configuration

In this example we have the following set-up

  • PBX has IP address 192.168.0.50
  • All numbers starting with "2" are routed to the N720
  • N720 has IP address 192.168.0.123
  • SIP accounts are configured using the internal numbers of the PBX.
    • Number 200 has username 200 and Password 200
    • Number 201 has username 201 and Password 201
    • .....
  • The internal number is in the Invite header, the PBX dials 200 and the Invite with number 200 is send. Device/handset with number 200 will ring.

Provider configuration

ParameterSetting
DomainIP address of Platform
Proxy server addressIP address of Platform
Registration serverlocalhost
Outbound server addresslocalhost
Outbound proxy modeNever

 

 

 

 

 

 

 

 

User/device configuration

ParameterDescription
Authentication nameInternal phone number
Authentication PasswordN.A.
UsernameInternal phone number
Display nameInternal phone number
(Can be seen on display handset)

 

 

 

 

 

 

Expand
titleT640/T440 example

PBX configuration

We used the Gigaset T640/T440 in this example.

SIP Gateway configuration

Column
width50%
ParameterDescription
RegistarIP address of N720
RegisterNo (No SIP registration)
GroupGateway group
Column
width50%

 

 

 

 

 

 

 

 

 

Gateway Group

Create a new gateway group with these settings.

 

 

 

 

 

 

 

 

Outbound routes

All numbers starting with 2 will be send to N720

 

 

Expand
titleInformation about Cisco configuration

The Cisco configuration is the same when you connect to an Asterisk PBX.

https://uccisco.wordpress.com/2014/05/16/cucm-asterisk-trunk-integration/

 

 

Column
width30%

Table of Contents