Page tree

Versions Compared

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.
Section
Column
width70%

Fasttel Door intercom - Interoperability

Tested with: Gigaset T300/T500 PRO: Software version 4.6.5.0
Fasttel Wizard Elite

Create SIP account in Gigaset T300/T500


Go to: Configuration - Phones - Add additional Telephones

Fasttel PBX.jpg

Use the settings like in the example above. Use the Password generator to create a secure Password

Open the Fasttel Wizard Elite door intercom web-interface

Go to Advanced Settings

SIP Server:                         IP address of the Gigaset T300/T500

Outbound Server:               IP address of the Gigaset T300/T500

SIP User ID:                        Telephone name defined in Gigaset T300/T500

Authenticate ID:                 Telephone name defined in Gigaset T300/T500

Authenticate Password:     Password defined in Gigaset T300/T500

Send DTMF                        Only activate the option via RTP(RFC2833)

NTP Server                        IP address of the Gigaset T300/T500

Basic Settings

Fasttel Basic.jpg

Status

Fasttel Status.jpg

 

Gigaset User account.

Without a Gigaset user account, the door intercom can be used to dial an internal number. Incoming and Outgoing calls are not possible.

Incoming calls to the door intercom are only possible when the door intercom is assigned to a user.

In the Gigaset T300/T500 Go to: Configuration - Users and create a new user, only to be used for the door intercom (user license)

Fasttel User.jpg

Programming the Fasttel using DTMF.

Call the extension number of the Doorintercom.

The Fasttel will answer the call and will play DTMF tones.

Then you enter the programming access code: *1996*

But, the Gigaset T300/T500 already uses the code *1 for Call recording. This means when you press *1996*, directly after the *1, the PBX will start recording the call and you will not be able to enter the programming mode. You need to change the *1 code in the Gigaset T300/T500 to an other code.

How to change the *1 code.

  • Login the PBX using SSH.
  • Go to the directory /home/asterisk
  • Open the file features.conf and change the automon => *1 to *4
  • Restart the PBX services to activate your chang
Background Color
#C0C0C0
#C0C0C0

 [featuremap]

 blindxfer => NONEXISTINGEXTENSION1 ; Blind transfer, default is #

 ;disconnect => *0               ; Disconnect

 automon => *4                  ; One Touch Record

 ;atxfer => *2                   ; Attended transfer

Column
width30%

Fasttel picture.jpg

Table of Contents

...