Versions Compared

Old Version 3

changes.mady.by.user Baremans, Eric

Saved on

compared with

New Version Current

changes.mady.by.user Kopowski Thomas

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.
Comment: Migrated to Confluence 5.3

Dean Connect

Section
Column
width80%70%
Feature                                                           
Outgoing CallsYes
Incoming CallsYes
CLIP incomingYes
CLIP outgoingYes
Call ForwardingYes
Call TransferYes
Call WaitingYes
DTMFYes
Anonymous CallYes
A-number forwardingNo

 

 

Column
width20%30%

Table of Contents

 

Gigaset T300/T500 settings.

In the Gigaset PBX go to "Configuration" - "Lines" - "Lines" and click on: New Line

New Line.jpgImage Removed

Provider settings:

Give the Line an unique name, you do not need to enter a username and password, because Dean Connect is working based on IP address

 

Dean Provider.jpgImage RemovedImage Added

In the Provider pull-down list, select "new.."

 

Image AddedDean Settings.jpgImage Removed

Number Area settings:

Just add the telephone numbers for this SIP trunk. The Country Code and Area Code can be filled in, if different than the default setting.

 

Image AddedDean NumberArea.jpgImage Removed

 

Info
titleImportant

With the 5.1.0.11 Release an issue is found with sending a BYE to disconnect the call, the issue is retested with the 5.2.0.10 release and is solved.

With the 5.2.0.10 Release, the following is important.

When the provider setting is set on auth mode: IP address, the Gigaset T300/T500 will send qualify messages even if the setting in the webinterface is on NO. You can change this by changing the setting in the file: /etc/asterisk/sip.conf. Search for the provider and change qualify to no. When changing the device/line setting, the sip.conf will be overwritten. Please remember this. Restart or reboot have no influence on the setting. Else, please ask Dean Connect to enable the qualify in their network.

...