Versions Compared

Old Version 8

changes.mady.by.user Baremans, Eric

Saved on

compared with

New Version Current

changes.mady.by.user Kopowski, Thomas

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.
Comment: Migrated to Confluence 5.3
Section
Column
width70%

Topex VoIP GSM gateway

Tested with:
Gigaset T300/T500 PRO: Software version 4.6.5.3
Mobilink IP Firmware version: Mobilink-IP-1.2.10-C1P-SDX

Section
In this example we started with a default Mobilink Gateway where we added a SIM card and disabled the SIM PIN code as described in the Mobilink manual.

 

Column
width50%

Settings in the Mobilink VoIP GSM Gateway


Go to: Network - IP settings

The Device should have a fixed IP address.
Settings are dependent of the customers network.

Column
width50%

 

Image AddedMobilink Network IP.jpgImage Removed

Section
Column
width50%

Go to: VoIP - Codec Settings

Column
width50%

 

Image AddedMobilink VoIP Codec.jpgImage Removed

Section
Column
width50%


Go to: VoIP - DTMF Settings

Change the DTMF Setting to RFC2833

Column
width50%

 

Mobilink VoIP DTMF.jpgImage RemovedImage Added

Section
Column
width50%

Go to: VoIP - Voice Settings

Gain can be adjusted dependent on the customers request

Column
width50%

 

Mobilink VoIP Voice.jpgImage RemovedImage Added

Section
Column
width50%

Go to: Call Control - Settings

Change the PBX IP address to the IP address of your Gigaset T300/T500

Column
width50%

 

Image AddedMobilink CallControl Settings.jpgImage Removed

Section
Column
width50%

Go to: Call Control - Incoming Calls

Change the settings Target, this number is dialled when a GSM call is coming in. In the Gigaset T300/T500, this is the external number that is configured and given to a user or a group.

Go to: Call Control - Outgoing Calls

 

Go to: Local Users - SIP Users

 

Column
width50%

 

Image Added

 

Image Added

 

Image Added

Mobilink CallControl Incoming.jpgImage Removed

Mobilink CallControl Outgoing.jpgImage Removed

Mobilink LocalUsers SIP.jpgImage Removed

 

 

 


 

Info
titleNo ringing during setup outgoing call

Extra, you need to set the option:

Menu - > Call Control -> Parameters -> Add the parameter: tx_progress 0

This will change that de device will not send the ringing signal through early media but using 180 Ringing.

 

Settings in the Gigaset T300/T500

 

Image AddedMobilink Provider.jpgImage Removed

Go to: Configuration - Lines and Add a new line.

Authentication: Yes
User Name: like defined in the Mobilink Gateway Local Users - Sip users
Password: like defined in the Mobilink Gateway Local Users - Sip users

Provider: Create a new provider.

 

Mobilink Provider Settings.jpgImage RemovedImage Added

Use the above settings.

host: IP address of the Mobilink VoIP GSM gateway

 

Mobilink Number Area.jpgImage RemovedImage Added

Add here the same number as defined in the Mobilink Gateway Call Control - Incoming Calls

 

Image AddedMobilink Extended.jpgImage Removed

Change the Max Connection: to match the number of GSM channels in the Mobilink Gateway, in this example we only had one channel.
We also added a Line Prefix for testing purposes.

Column
width30%

 

Topex.jpgImage RemovedImage Added

Table of Contents