Versions Compared

Old Version 4

changes.mady.by.user Baremans, Eric

Saved on

compared with

New Version Current

changes.mady.by.user Simone, Cristian

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.
Section
Panel
titleColor#F85404
titleBGColor#F0F0F0
titleThird party antennas

Smau

Instead of the Gigaset external antennas, you can connect also third party antennas. Below are the Microset antennas.


Gigaset does not sell these antennas !!!


Info

Always replace both Gigaset antennas with the same external third party antennas, only then the optimum DECT quality is obtained.  Some antennas mentioned below have one connector, this means that you need to buy 2 antennas.


  • Connect both external antennas to maintain antenna diversity
  • The antennas should be of the same type
  • Keep at least 30 cm between the antennas
  • Place both antennas in the same area. One inside and one outside is not supported
  • Antenna cables should be of the same type and length, keep the length as short as possible
  • Every meter of cable will be … dB gain loss (depends on the used cable)


Microset AntennaCharacteristicDiagram

MP10-4

Image Modified

Frequency range (MHz): 1700- 2200 
Input impedance (Ω): 50     
V.S.W.R: ≤ 1.5     
Gain (dB): 12    
Polarization type: Vertical     
Connector: TNC female              Environment: Internal 

Image Modified

MP10-4S

Image Modified

Frequency range (MHz): 1700- 2200 
Input impedance (Ω): 50     
V.S.W.R: ≤ 1.5     
Gain (dB): 12    
Polarization type: Vertical     
Connector: TNC female              Environment: External, cold rooms

Image Modified

C7-LTE

Image Modified

Frequency range (MHz): 1700- 2200 
Input impedance (Ω): 50     
V.S.W.R: ≤ 1.5     
Gain (dB): 8
Polarization type: Vertical     
Connector: TNC female              Environment: Internal (ceiling mounting)

Image Modified

MD14

Image Modified

Frequency range (MHz): 1700- 2200 
Input impedance (Ω): 50     
V.S.W.R: ≤ 1.5     
Gain (dB): 14
Polarization type: Vertical     
Connector: TNC female              Environment: Internal or External

Image Modified

COL2 (2 x MD14)

Image Modified

Frequency range (MHz): 1700- 2200 
Input impedance (Ω): 50     
V.S.W.R: ≤ 1.5     
Gain (dB): 14
Polarization type: Vertical     
Connector: TNC female              Environment: Internal or External

Image Modified

MD6

Image Modified

Frequency range (MHz): 1700- 2200 
Input impedance (Ω): 50     
V.S.W.R: ≤ 1.8     
Gain (dB): 6
Polarization type: Vertical     
Connector: TNC female              Environment: External

Image Modified

Coax extension cable of 1m: COAX1

Product code: 4041527                  Connectors: TNC male / TNC male


Coax extension cable of 5m: COAX5Product code: 4041526                      Connectors: TNC male / TNC male
Coax extension cable of 10m: COAX10Product code: 4041483                      Connectors: TNC male / TNC male