Versions Compared

Old Version 2

changes.mady.by.user Baremans, Eric

Saved on

compared with

New Version Current

changes.mady.by.user Huggett, Paul

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.
Section
Column
width70%

Introduction

You can operate multiple door interphones using your telephoneMaxwell 10S. If you receive a call from the door interphone, the display shows a picture or video from the connected video camera.

For configuration details see here


Tested door interphones

 

Info
titleImportant

In the current software only jpg support is offered, this will be extended soon.

 

Configuration

Image Removed

Operating door interphones.

Door intercomKnown Camera (URL)
Felicomhttp://<IP-address CP-CAM>/jpg/image.jpg
StentofonBaudischhttp://<IP-address CP-CAM>/jpg/image.jpg
TCS

http://argos_ip/video.jpg

2Nhttp://<IP-address EntryCom IP>/enu/camera1280x960.jpg (or 160x120, 320x240, 640x480, 176x144, 322x272, 352x288)
Protalk

http://<IP-address Protalk>/video.jpg

Koch

http://<ip-address AVS110>:12000/video.jpg (Reload rate 50)
Nista Devices

http://<IP address nista>:8080/file.jpg (software release 2abw03 or higher is required)

Mobotix

http://<username>:<password>@<IP address Mobotix>/record/current.jpg

(e.g. http://admin:12345@192.168.0.101/record/current.jpg)


Operating door interphones.

When receiving an incoming call from the door intercom, you will see the picture from the door intercom refreshed every ... msec (Reload rate)

Image Added

When the call is answered, you will see the Picture from the door intercom in the screen again refreshed every .. msec.

Image Added

When the door intercom supports Video/Jpeg, you can click on "VIDEO CALL" where the device then will setup a video/Jpeg stream between the door intercom and the Maxwell 10.

Image Added 

Column
width30%

Table of Contents