Page tree

Versions Compared

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.
Align
alignright
Valid for: N670 N870N870E
Section
Panel
titleColor#F85404
titleBGColor#F0F0F0
titleResetting the device to factory settings

You can reset the device to factory default via: Image Removed

  • Web-interface
  • Changing the device role using the key procedure
  • Power procedure
  • Emergency reset to factory settings



Panel
titleColor#F85404
titleBGColor#F0F0F0
titleWeb-interface

Open the web-interface and go to: SETTINGS - System - Reboot and reset - Reset to

Select the role of the device that it should have after factory reset.

  • All in one - dynamic IP (Integrator + DECT Manager + DECT base)
  • All in one - static IP (Integrator + DECT Manager + DECT base)
  • DECT manager + Base - dynamic IP (Device is connected to Virtual or Embedded Integrator)
  • DECT manager + Base - static IP (Device is connected to Virtual or Embedded Integrator)
  • Integrator only - dynamic IP (Embedded Integrator)
  • Integrator only - static IP (Embedded Integrator)





Panel
titleColor#F85404
titleBGColor#F0F0F0
titleResetting base stations to factory settings via power procedure

Resetting the device to factory settings is performed by interrupting the boot process.

  • Remove the power supply from the device (unplug the LAN cable).
  • Replug the LAN cable or the power supply unit . . . the reboot starts. If the boot process is not interrupted, the standard reboot is performed.
  • Interrupt the boot procedure after 30 sec. at the earliest and 40 sec. at the latest.

    Once: The device is reset as Integrator/DECT manager with a dynamic IP settings.
    Two times: The device is reset as base station.
    Four times: The device is reset as Integrator/DECT manager/base station with dynamic IP settings.



Panel
titleColor#F85404
titleBGColor#F0F0F0
titleEmergency reset to factory settings

When the device is booting

  • Press the device button for at least 10 seconds until all LEDs switch off release the button . . . the device is now in programming mode.
  • Press the device button until the LED lights green
  • Press the device button for at least four seconds . . . the device is reset and rebooted.



Info
titleInfo

This procedure resets all the settings you have made for the device. The procedure deletes the saved data from the base stations and handsets. The base station's assignment to the DECT manager is cancelled. Ongoing calls are cancelled. In the case of an Integrator/DECT manager the whole configuration is reset.

To enable the restoration of your system configuration after a reset, you should regularly save the configuration data to a file.