This page describes how the Gigaset Nx70 devices are provisioned behind the Yeastar S-series. 

For this wiki article, we used:

  • Yeastar S20 software 30.12.0.9
  • Yeastar auto-provisioning app version 1.8.24 (Contains Nx70 provisioning)
  • Nx70 software 2.29.0

Yeastar implemented HTTPS provisioning to support also devices without the TFTP protocol.

The Yeastar will send a SIP NOTIFY with Event: check-sync;reboot=true to start provisioning, this means that the device is rebooted to trigger the provisioning. The reboot is a Yeastar requirement as Gigaset devices do not need a reboot.

  1. Start with an factory default Nx70 with software 2.29.0 or higher. 
  2. During boot the Nx70 will send a SIP multicast and the device will be visible in the Yeastar Auto Provisioning App.

3. Via the Edit button configure your device

4. Save the configuration

5. Reboot the Nx70

6. The device is configured after reboot


After this, it is not needed to reboot the device anymore, even if it is mentioned in the Yeastar web-interface.

Changes made in Yeastar are triggered via sip-notify and provisioning is started without a reboot.

The following features are supported by the Yeastar Auto provisioning App.

  • N670 up to 20 handsets
  • N870 up to 50 handsets
  • LDAP phone-book
  • Call Waiting
  • Voicemail
  • Language
  • Admin Password
  • Tone scheme
  • Time zone
  • NTP server
  • Codecs
  • Firmware update

Add handsets/Accounts

You can configure your handsets by selecting the Extension and define the (internal) LDAP service.

To register the handset you need to open the Nx70 web-interface and start registration.

Features

Preferences

  • Admin Password: In the field, configure your admin password. If this is empty, your password entered during Nx70 installation will not be overwritten.


Codec

If you disable the G.729 codec you will have more channels on the DECT base. (10 instead of 8)


LDAP

  • Directory name: The name of the phone-book, visible in the DECT handsets,
  • Server Address: The IP address of the Yeastar PBX
  • Server Port: The LDAP server port (389)
  • LDAP Search base (Base DN): dc=pbx,dc=com
  • Username: cn=admin,dc=pbx,dc=com
  • Password: password


Firmware update

Via the firmware update page you can add the latest software. You need to start provisioning by entering the Nx70 config in Yeastar and just press save.

Yeastar will send a SIP notify and provisioning/firmware update is then started.