In this mode Feature Key is working as an alarm trigger (Display_2, Display_3). There are two independent alert configurations. Each configuration has its own settings. - Short press of feature key (SFK)
- Long press of feature key (LFK)
Remarks - When feature key and alarm mode are set, at least one alarm type has to be activated
Display_1 | Display_2 | Display_3 | Display_4 | Display_5 | Display_6 |
---|
| | | | | |
Alarm mode callPressing of Feature Key will result in, depending on settings: - An active connection to base station is disconnected
- An incoming call in progress, is answered and disconnected (to release line)
- HS might start playing alarm melody/sound via loudspeaker for configured time slot.
- Blinking Spot LED <<<depends on hardware>>>: Spot LED can be activated to blink in SOS sequence (with Morse alphabet, 3x long, 3x short, 3x long)
Alarm mode call is set up to a number defined in settings. Base station has information that it is a special call to avoid forcing user to select line (relevant for multi-line systems) As a consequence of call being regular call, it is possible to interrupt it by the same events that interrupts regular call (including Feature key). Handset blinks with spot LED, if configured by user <<<depends on hardware>>> Remarks 1. If the Alarm mode is set but the number is empty or activation for key press(SP/LP) is not configured (Possible from factory settings), then pressing feature key will open the configuration menu 2. If handset is not synchronized to base station, Display_6 is shown instead of call setup. 3. If pre alerting is in progress, it is possible to change alert (if started with LFK, can be changed to SFK and if started with SFK, can be changed to LFK) simply by pressing appropriate key. Using SFK or LFK when the corresponding procedure is ongoing. will not result in restarting pre alert. Pre Alert notificationPre alert notification is a special state before alert-call is performed. It is ignored if alarm delay is set to 0 sec. In this state: - Handset plays melody with configured volume for the time selected by user,
- Handset blinks with spot LED, if configured by user <<<depends on hardware>>>,
- Handset shows Display_1,
- Handset counts down to 0, afterwards call is started.
- Name replacement is not supported in this state
Procedure can be canceled by softkey "Cancel", or change alert type (LFK / SFK), no other events should stop pre alerting. Procedure can be skipped by softkey "Call now" / SEND key / center key, in this case counting is cancelled and call is started immediately. |