Scope
- New: All settings of a DECT manager, including DECT registrations can be saved and uploaded to the same or another DECT manager.
- Up to now restoring was only possible to the same device and did not include DECT handset registrations.
- Use case: Quickly get system up and running again when a DECT manager is broken. Minimize downtime.No need to register handsets anew.
- Web UI recommends to save settings after changes.
- Caution: Do not operate original and cloned DECT manager in parallel. This will cause severe network troubles.
How to:
Save settings from old device
- DECT Manager firmware version needs to be equal or higher than 70.087.*.*.* in order to support clone feature
- Clone is also supported when saving settings from already cloned devices
- Saving settings is done by WebUI “Management -> Save and restore -> Save Device Settings to PC“
Clone settings to new device
- Firmware version of new device has to be equal or greater than device from which settings were saved
- If old device used permanent patches, it is required to apply these permanent patches to new device before cloning settings from old device
- Be sure that the old device is no longer used before proceeding
- Clone settings by WebUI “Management -> Save and Restore -> Restore Device Settings from PC”
Notes
- After reset to factory all settings (including clone information) are lost
- All kind of patches are still supported with cloned device (normal-, permanent- and wipeout-)