Wall mounting

To ensure that the system can operate free of faults, it must be mounted upright on a wall.

The ventilation openings must be kept uncovered. The gaps in the drilling template should be complied with. Do not cover the device with curtains, towels, etc.

• Find an installation site which is a maximum of 1.5 meters away from a 230 V mains socket and 2.5 meters from the network operator's transfer point.

• To prevent devices interfering with each other, do not install the device close to electronic devices such as hi-fi systems, office equipment or microwave ovens. Neither should you install it near heat sources such as radiators, or in damp rooms

• Comply with the gaps as indicated at the in the picture.
• Mark the drilling holes in the wall.

• Check that all the points where the system is attached to the wall can bear its weight. Ensure that there are no utility lines, cables etc. located in the area where the holes are marked.

• Drill the holes at the points marked (if inserting into rawlplugs, use a 5 mm masonry drill). Insert the rawlplug.

• Screw the top two screws in such a way that there is still a gap of about 5 mm between the screw head and the wall.
• Open the device by carefully removing the faceplate.

• Hang the system with the rear brackets from above behind the screw heads.

• Screw the lower screws through the device so that it is fixed firmly to the wall.

• If necessary, install the sockets for the terminals. Connect the socket installation to that of the device. The sockets are used for a permanent installation, for example in a
  hallway. When they are installed, the connecting cables are connected to the connectors on the device,

• Plug the connectors on the device into the sockets.
• Connect the system to the external connections.
• Plug the power supply unit into the 230 V~ socket.

• Plug the barrel connector on the power supply unit into the corresponding socket on your device.

• Now you are ready to use the device.