Access via the Serial Interface

The Hybird 120 GE features a serial interface which allows a direct connection with a PC. Below describes what you have to remember when setting up a serial connection and what you can do to configure your device in this way.

 

Caution

Access via the serial interface is only recommended for service technicians for debug purposes and if no LAN access is possible via the pre-configured IP address (192.168.0.250/255.255.255.0). The possible operations that can be run are displayed if you enter ? in the command line and confirm with the Enter key.

Windows

If you are using a Windows PC, you need a terminal program for the serial connection, e.g.HyperTerminal. Make sure that HyperTerminal was also installed on the PC with the Windows installation. However, you can also use any other terminal program that can be set to the corresponding parameters (see below).

Proceed as follows to access your device via the serial interface:

  1. Start the terminal program, e. g. HyperTerminal.
  2. Press Return (at least once) after the HyperTerminal window opens.

A window with the login prompt appears. You are now in the SNMP shell of your device.
You can now log in on your device and start the configuration.

Check

If the login prompt does not appear after you press Return several times, the connection to your device has not been set up successfully.
Therefore, check the COM1 or COM2 settings on your PC.

  1. Click on File ->Properties.
  2. Click Configure in the Connect to tab.
    The following settings are necessary:
    - Bits per second: 9600
    - Data bits: 8
    - Parity: open
    - Stopbits: 1
    - Flow control: open
  3. Enter the values and click OK.
  4. Make the following settings in the Settings tab:
    - Emulation: VT100
  5. Click OK.

The changes to the terminal program settings do not take effect until you disconnect the connection to your device and then make the connection again.

If you use HyperTerminal, there may be problems with displaying umlauts and other special characters. If necessary, therefore, set HyperTerminal to Autodetection instead of VT100

Driver

Click here to download the USB driver.

 

Question:

Can the serial interface be used to send out Call Data Records to other systems like Hotel solutions?

Answer:

No, this system has no possibility to send out Call Data Records to other Applications via the Serial Interface. .

  • No labels