Versions Compared

Old Version 8

changes.mady.by.user Baremans, Eric

Saved on

compared with

New Version 9

changes.mady.by.user Baremans, Eric

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.
Section
Panel
titleColor#F85404
titleBGColor#F0F0F0
titleIntroduction

This page describes how the Gigaset Nx70 devices are provisioned behind the Yeastar S20.S-series. Image Added

For this wiki article, we used:

  • Yeastar S20 software 30.12.0.9
  • Yeastar auto-provisioning app version 1.8.24
  • Nx70 software 2.29.0

Yeastar implemented HTTPS provisioning to support also devices without the TFTP protocol.

The Yeastar will send a SIP NOTIFY with Event: check-sync;reboot=true to start provisioning, this means that the device is rebooted to trigger the provisioning. The reboot is a Yeastar requirement as Gigaset devices do not need a reboot.

Panel
titleColor#F85404
titleBGColor#F0F0F0
titleFirst steps to connect Nx70
  1. Start with an factory default Nx70 with software 2.29.0 or higher. Image Added
  2. During boot the Nx70 will send a SIP multicast and the device will be visible in the Yeastar PBXAuto Provisioning App.

3. Via the Edit button configure your device

4. Save the configuration

5. Reboot the Nx70

6. The device is configured after reboot


Info

After this, it is not needed to reboot the device anymore, even if it is mentioned in the Yeastar web-interface.

Changes made in Yeastar are triggered via sip-notify and provisioning is started without a reboot.

Panel
titleColor#F85404
titleBGColor#F0F0F0
titleConfiguration

The following features are supported by Yeastar

  • N670 up to 20 handsets
  • N870 up to 50 handsets
  • LDAP phonebookphone-book
  • Call Waiting
  • Voicemail
  • Language
  • Admin Password
  • Tone scheme
  • Time zone
  • NTP server
  • Codecs
  • Firmware update

Add handsets/Accounts

You can configure your handsets by selecting the Extension and define the (internal) LDAP service.

Yeastar S20 - Nx70 autoprovisioningImage Added

To register the handset you need to open the Nx70 web-interface and start registration.

Features

Preferences

  • Admin Password: In the field, configure your admin password. If this is empty, your password entered during Nx70 installation will not be overwritten.


Codec

If you disable the G.729 codec you will have more channels on the DECT base. (10 instead of 8)


LDAP

  • Directory name: The name of the phone-book, visible in the DECT handsets,
  • Server Address: The IP address of the Yeastar PBX
  • Server Port: The LDAP server port (389)
  • LDAP Search base (Base DN): dc=pbx,dc=com
  • Username: cn=admin,dc=pbx,dc=com
  • Password: password


Firmware update

Via the firmware update page you can add the latest software. You need to start provisioning by entering the Nx70 config in Yeastar and just press save.

Yeastar will send a SIP notify and provisioning/firmware update is then started.