Versions Compared

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.
Section
Column
width70%

Introduction

You can operate multiple door interphones using your telephoneMaxwell 10S. If you receive a call from the door interphone, the display shows a picture or video from the connected video camera.

For configuration details see here

 


Tested door interphones

 

Door intercomKnown Camera (URL)
Felicomhttp://<IP-address CP-CAM>/jpg/image.jpg
StentofonBaudisch
 
http://<IP-address CP-CAM>/jpg/image.jpg
TCS
 

http://argos_ip/video.jpg

2Nhttp://<IP-address EntryCom IP>/enu/camera1280x960.jpg (or 160x120, 320x240, 640x480, 176x144, 322x272, 352x288)
Protalk

http://<IP-address Protalk>/video.jpg

 

Koch

http://<ip-address AVS110>:12000/video.jpg (Reload rate 50)
Nista Devices

http://<IP address nista>:8080/file.jpg (software release 2abw03 or higher is required)

Mobotix

http://<username>:<password>@<IP address Mobotix>/record/current.jpg

(e.g. http://admin:12345@192.168.0.101/record/current.jpg)


Operating door interphones.

When receiving an incoming call from the door intercom, you will see the picture from the door intercom refreshed every ... msec (Reload rate)

When the call is answered, you will see the Picture from the door intercom in the screen again refreshed every .. msec.

When the door intercom supports Video/Jpeg, you can click on "VIDEO CALL" where the device then will setup a video/Jpeg stream between the door intercom and the Maxwell 10.

Column
width30%

Table of Contents