Introduction

Here we describe how the Sennheiser DW Office is connected to the Maxwell 10.

Connecting Base Station to the Maxwell

• Use a normal 8 pin Ethernet cable (17)
• Connect to the Sennheiser Base station Phone socket.(8)
• Connect to the Maxwell 10 EHS socket.

Sennheiser DIP switch settings

• Set the DIP switch 1 and 4 to the lower position.

Adjusting the audio signal

• Set the ABC switch (6) to A (Default), B or C so that you can hear a clear signal.

Adjusting the Microphone sensitivity

• To change the volume, adjust the microphone volume control accordingly

Signalling of incoming call (Ringing in headset)

It is possible to enable/disable the option that an incoming call can be signalled via audio in the Headset, for this, the following option needs to be enabled:

In the right top corner of the Maxwell 10, pulldown the settings menu and via the menu: Headset you can:

Headset ON - Audio signal in Headset during incoming ring.

Headset OFF - No audio signalling in Headset when receiving call