FAQ - Reboot and Reset to factory default

You can reset the device to factory default via: 

• Web-interface
• Changing the device role using the key procedure
• Power procedure
• Emergency reset to factory settings

Open the web-interface and go to: SETTINGS - System - Reboot and reset - Reset to

Select the role of the device that it should have after factory reset.

• All in one - dynamic IP (Integrator + DECT Manager + DECT base)
• All in one - static IP (Integrator + DECT Manager + DECT base)
• DECT manager + Base - dynamic IP (Device is connected to Virtual or Embedded Integrator)
• DECT manager + Base - static IP (Device is connected to Virtual or Embedded Integrator)
• Integrator only - dynamic IP (Embedded Integrator)
• Integrator only - static IP (Embedded Integrator)

Resetting the device to factory settings by power procedure could only be applied to devices in role base-only.
Reset to factory settings can be performed by re-powering the device between 30s and 40s since power-up.
The number of repetitions of re-power during the time window of 30s to 40s since power-up, 
is defining the role-set, to which the base is reset:

• First power-up + two additional re-power in time window 30s - 40s since previous power-up:  ==> will end in a reset to base role.
• First power-up + four additional re-power in time window 30s - 40s since previous power-up:  ==> will end in a reset to base-dm-int role

When the device is booting

• Press the device button for at least 10 seconds until all LEDs switch off release the button . . . the device is now in programming mode. Left LED lights green.
• Press the device button for at least four seconds  and no longer than 10 seconds. . . the device is reset and rebooted.