You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 3 Next »

Introduction

If you want to know if the network of the customer can be used for LAN synchronization, you can use the N870 to check the network.

The first you need to do is to configure the customer network.

  1. Add VLAN's
  2. Activation of Quality of Service mechanism, LAN synchronization should have higher priority.
  3. Check if the customer switches are not overloaded. Or overloaded at certain time during the day.
  4. The less switches that are used, the better.
  5. Deactivate Enhanced packet processing logics.

Install in the customer network at some strategic points the N870 with some base-stations. They do not have to mounted to the wall, but connected to the switch.

Like in the example below. We installed some N870 base-stations in the customer network, Every base station is connected to one of the customers switches.

  • On the laptop we installed a syslog server, or you can use an syslog server installed at another location like your own office. (Must be reachable from the customer network.)
  • Activate in the N870 the syslog and enter the IP address of the laptop (or external syslog server)
  • Enable the CLI access on the Integrator / DECT manager.



  • No labels