You are viewing an old version of this page. View the current version.

Compare with Current View Page History

Version 1 Next »

Introduction

This page describes how the Gigaset Nx70 devices are provisioned behind the Yeastar S20.

  • Yeastar S20 software 30.12.0.9
  • Yeastar auto-provisioning app version 1.8.22
  • Nx70 software 2.29.0

Yeastar implemented HTTPS provisioning to support also devices without the TFTP protocol.

The Yeastar will send a SIP NOTIFY with Event: check-sync;reboot=true to start provisioning, this means that the device is rebooted to trigger the provisioning. The reboot is a Yeastar requirement as Gigaset devices do not need a reboot.

First steps to connect Nx70
  1. Start with an factory default Nx70 with software 2.29.0 or higher.
  2. During boot the Nx70 will send a SIP multicast and the device will be visible in the Yeastar PBX.

3. Start your configuration

4. Reboot the Nx70

5. The device is configured after reboot


...


  • No labels