Introduction.

The N870 has only one hardware, not like the N720 where a separate DECT manager and DECT base is available.

When you connect an N870 to the Power, it will start by default as a base station. You can change the role of the device using the following procedure.

Per default, the device is delivered as a base station.

To change the role to a DECT Manager or to reset the base, please follow this instruction.

To activate the programming mode, press and hold the hardkey for minimum 10 seconds.
After 10 seconds, the LED's will be switched off and the device is in the programming mode.
In programming mode you can step through the three options by single key presses.
The modes are indicated by the LEDs.
To activate the intended option: Press and hold the hardkey for 5 seconds (minimum 3 up to maximum 10 seconds).
The programming mode is closed after 20 sec of no activity.

Remark: Please be aware that existing configuration and user data will be lost. Please perform backup in advance if needed

Example how to change role to DECT manager and DECT base in one.

Press key for 10 seconds, until LED's are switched off.
Green LED will be On and role is DECT Base.
Press key and both LED's will be Blue.
Press key for 5 seconds.
Device will reboot and will come online as DECT Manager and Base, with factory default settings.

Programming mode:

Progr. option	Role	IP	Reset to factory settings	Password Web Configurator	Description	LED 1	LED 2	activate by
0					Programming mode	off	off
1	Base station		yes		Set role to base station (default).		Green	press & hold key for 5 seconds
2	Base station + DECT Manager	DHCP IP adress obtained automatically	yes	admin	Set role to Base + DECT Manager + Integrator.	Blue	Blue	press & hold key for 5 seconds
3	Base station + DECT Manager	Static IP: 192.168.143.1 Subnet mask: 255.255.0.0	yes	admin	Set role to Base + DECT Manager + Integrator and apply static IP adress.		Blue	press & hold key for 5 seconds

Page tree

FAQ N870 - Installation

Introduction.

Programming mode: