Introduction

Web-interface: http://<IP address>/#/Expert 

Login as admin and switch to the above URL.

Port Mirroring

Port Mirroring can be activated by setting the switch to "YES".
The NET port will be mirrored to the PC port. Furthermore the PC can be used to access the Web-UI as well.

Link Speed & Duplex Mode

For NET and PC port the settings can be set to a fixed value (see drop-down list).

ATTENTION!

  1. This is only working properly, if the Swtich port is set to the same value!
  2. The speed between Maxwell b3 switch and DSP is fixed to 100 MBit/s

Allow fragmentation

To activate this function the checkbox needs to be activated. On activation the flag "Don't fragment" is unset.

This allows the usage of Maxwell, even if pakets/Frames are sent which exceed the MTU (Maximum Transmission Unit) which is normally 1.500 Byte using Ethernet.
Some routers may have a smaller MTU defined.


Auto provisioning
ParameterDescription
NET.SwitchSettings.EnablePortMirroringEnable port mirroring:
0 = Disabled
1 = Enabled
NETWORK.SwitchSettings.LinkSpeedDuplexLanPort

Link speed and duplex mode - LAN Port

Autonegotiation
10 Mbit Half-Duplex
10 Mbit Full-Duplex
100 Mbit Half-Duplex
100 Mbit Full-Duplex
1000 Mbit Full-Duplex

NETWORK.SwitchSettings.LinkSpeedDuplexPcPort

Link speed and duplex mode - PC Port

Autonegotiation
10 Mbit Half-Duplex
10 Mbit Full-Duplex
100 Mbit Half-Duplex
100 Mbit Full-Duplex
1000 Mbit Full-Duplex
Disabled

NET.SwitchSettings.AllowFragmentation

Allow fragmentation of frames
0 = Disabled
1 = Enabled







  • No labels