Versions Compared

Old Version 1

changes.mady.by.user Baremans, Eric

Saved on

compared with

New Version 2

changes.mady.by.user Baremans, Eric

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.
Section
Panel
titleColor#F85404
titleBGColor#F0F0F0
titleIntroduction

This page describes how the Gigaset Nx70 devices are provisioned behind the Yeastar S20.

  • Yeastar S20 software 30.12.0.9
  • Yeastar auto-provisioning app version 1.8.22
  • Nx70 software 2.29.0

Yeastar implemented HTTPS provisioning to support also devices without the TFTP protocol.

The Yeastar will send a SIP NOTIFY with Event: check-sync;reboot=true to start provisioning, this means that the device is rebooted to trigger the provisioning. The reboot is a Yeastar requirement as Gigaset devices do not need a reboot.

Panel
titleColor#F85404
titleBGColor#F0F0F0
titleFirst steps to connect Nx70
  1. Start with an factory default Nx70 with software 2.29.0 or higher.
  2. During boot the Nx70 will send a SIP multicast and the device will be visible in the Yeastar PBX.

3. Start your configuration

4. Reboot the Nx70

5. The device is configured after reboot


Info

After this, it is not needed to reboot the device anymore, even if it is mentioned in the Yeastar web-interface.

Changes made in Yeastar are triggered via sip-notify and provisioning is started without a reboot.

Panel
titleColor#F85404
titleBGColor#F0F0F0
title...