You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 2 Next »

Introduction

This page describes how the Gigaset Nx70 devices are provisioned behind the Yeastar S20.

  • Yeastar S20 software 30.12.0.9
  • Yeastar auto-provisioning app version 1.8.22
  • Nx70 software 2.29.0

Yeastar implemented HTTPS provisioning to support also devices without the TFTP protocol.

The Yeastar will send a SIP NOTIFY with Event: check-sync;reboot=true to start provisioning, this means that the device is rebooted to trigger the provisioning. The reboot is a Yeastar requirement as Gigaset devices do not need a reboot.

First steps to connect Nx70
  1. Start with an factory default Nx70 with software 2.29.0 or higher.
  2. During boot the Nx70 will send a SIP multicast and the device will be visible in the Yeastar PBX.

3. Start your configuration

4. Reboot the Nx70

5. The device is configured after reboot


After this, it is not needed to reboot the device anymore, even if it is mentioned in the Yeastar web-interface.

Changes made in Yeastar are triggered via sip-notify and provisioning is started without a reboot.

...


  • No labels