You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 3 Next »

Introduction

From software ... we have introduced 3 new statistics that shows information about the LAN Synchronization quality.

The measurement is done every ... seconds.

Statistic
q-idx-ltLAN synchronization quality


How is this value calculated ?
o-thr-excPTP offset threshold exceeded


If the PTP deviation > 500 ns seconds, the counter is increased.

That the counter is increased means that the network does not meet the requirement that the PTP deviation is < 500 ns.

  1. Values > 500 ns are accepted and might just generate some warnings.
  2. Values > 500 ns for a longer time or very high over the 500 ns will result in an Asynchronization where all calls via this DECT base are disconnected.

DECT base that loses synchronization needs up to 30 seconds to synchronize again (When the LAN synchronization can be started again)

d-thr-excDLS offset threshold exceeded


If the DLS deviation > 1000 ns seconds, the counter is increased.Based on the PTP synchronization LAN Master and LAN slave adjust their DECT reference timer to one Common offset to the common PTP reference timer. This common offset will be permanently monitored by a proprietary communication.

Asynchronisation

The column Async must also be used to check if the network is LAN synchronization capable. You can see in the picture that we have many PTP threshold exceeded (13379) but there is no Synchronization loss. Theoretical it would not provider problems. But you can expect that if the PTP deviation is getting worse, it will result in synchronization loss.




  • No labels