You are viewing an old version of this page. View the current version.

Compare with Current View Page History

Version 1 Next »

Introduction

 

For support purposes, we need to be able to use "Live" debugging mode. For this on the "Expert" page, the CLI is implemented.

Web-interface: http://<IP address>/#/Expert - Network - Switch Settings

Port Mirroring

Port Mirroring can be activated by setting the switch to "YES".
The NET port will be mirrored to the PC port. Furthermore the PC can be used to access the Web-UI as well.

Link Speed & Duplex Mode

For NET and PC port the settings can be set to a fixed value (see drop-down list).

ATTENTION!

  1. This is only working properly, if the Swtich port is set to the same value!
  2. The speed between Maxwell b3 switch and DSP is fixed to 100 MBit/s

Allow fragmentation

To activate this function the checkbox needs to be activated. On activation the flag "Don't fragment" is unset.

This allows the usage of Maxwell b3, even if pakets/Frames are sent which exceed the MTU (Maximum Transmission Unit) which is normally 1.500 Byte using Ethernet.
Some routers may have a smaller MTU defined.

 

 

  • No labels